FRP(Fiber-Reinfroced Plastic) Material
The selections of resin and fiberglass are based on fabric compatibility, service
conditions, and the desired characteristics of the finished part.
1. Gel Coats:
    Gel Coats are special polyester resins which are used on part surfaces. We 
    apply the gel coats on all of our FRP products to improve surface appearance
    and bonding.
2. Resin:
    We chose the high strength, high impact resistance polyester resin to make
    stronger products.
3. Fiberglass: 
    Good quality cloth and mats are relatively lightweight, high tensile and
    compressive strenght.

   The Fabrication Process
The fabrication process on our parts are same to the steps followed in making
the mold. A reinforced sandwich core construction is built on every FRP parts.
Each layer is saturated and compact as much as possible to achieve the best
result.

   Preheated FRP Products
All of our FRP products have been preheated with 140 degree F(60 degree C)
for a suitable of time. So, it will always be a stable condition and quility.
We suggest our customer set up a lower tempreature and short time to baking
the products when it needed. Don't over heat the FRP products.